News and Events

[NEWS] PVC Recycling Production Line: From Grinding, Washing to Drying 2026-11-13

Anda PVC recycling line turns rigid scrap into 10-40 mesh powder for regrind blending, with grinding, washing and drying stages matched to your scrap type.

[NEWS] Co-Extrusion WPC Decking Production Line: Layer Structure, Die and Surface Finishing 2026-11-12

A co-extrusion WPC decking line builds a WPC core and a UV-resistant cap in one pass, then sets it on the vacuum table and finishes the cap with 3D wood grain.

[NEWS] PVC Soffit Panel Line Layout: Space, Utilities and Output Planning 2026-11-06

Plan a soffit panel line that fits the hall: straight run, real 60-70% running power, and output across three line speeds - each tied to a quotation figure.

[NEWS] How the 3-Roll Calender Keeps PVC Marble Sheets Flat for UV Mirror Finishes 2026-11-05

A UV mirror finish turns tiny sheet undulations into visible ripple. See how the die and 3-roll calender hold PVC marble sheets flat at ±0.05 mm.

[INDUSTRY NEWS] UPVC Profile Size Drift: Die, Calibration and Haul-Off 2026-10-30

Trace UPVC profile size drift through die flow, vacuum calibration, cooling and haul-off with a measured, station-by-station check.

[INDUSTRY NEWS] Choosing a 4-Roller PVC Laminate Sheet Line 2026-10-29

Compare four-roller PVC laminate sheet lines by finished-sheet specs, film setup, cooling, utilities and accepted output.

[INDUSTRY NEWS] WPC Foam Board Pinholes, Warping and Rough Skin Causes and Fixes 2026-10-23

Fix WPC foam board pinholes, warping after cutting, and rough skin by finding the earliest defect point. Practical checks for die, cooling, and calibration.

[INDUSTRY NEWS] PVC Edge Band Winding Defects: Tension, Cooling and Roll Shape 2026-10-22

[INDUSTRY NEWS] Control WPC Fluted Panel Weight Without Thin Walls 2026-10-16

Learn how to control WPC fluted panel weight without thinning walls through optimized material formulas, density control, and stable extrusion technology.

[INDUSTRY NEWS] How to Stop UPVC Profile Bowing and Twisting After Extrusion 2026-10-15

Stop UPVC profile bowing and twisting after extrusion by optimizing cooling, vacuum calibration, temperature control, and haul-off speed.

[INDUSTRY NEWS] WPC Fluted Panel Grain Transfer Pressure and Heat Guide 2026-10-10

Set WPC fluted panel grain transfer pressure, heat and speed without flattened ribs or weak wood patterns. A practical line-side defect guide.

[INDUSTRY NEWS] How to Balance Four PVC Edge Band Lanes Without Color or Gauge Drift 2026-10-09

Learn how to balance four PVC edge band lanes, control color and thickness drift, and improve output with practical die, cooling, printing, and winding checks.